高强不锈钢绞线网与ECC黏结-滑移关系模型

高强不锈钢绞线网与ECC的黏结是二者协同工作的基础，且黏结 滑移关系模型是其黏结性能的综合反映，故通过对17组51个高强不锈钢绞网增强ECC薄板试件进行单边拉拔试验，研究横向钢绞线间距、纵向钢绞线直径和相对锚固长度等因素对钢绞线网在ECC中黏结性能的影响规律。试验结果表明，横向钢绞线的设置可使黏结破坏由脆性破坏转变为延性破坏；高强不锈钢绞线网与ECC的黏结滑移曲线可分为5个阶段，分别为上升段、微降段、延性强化段、下降段和残余段。基于试验结果，对钢绞线网在ECC中的黏结破坏特征和黏结 滑移机理进行分析，在相关黏结-滑移关系模型的基础上，提出钢绞线网与ECC的黏结 滑移关系模型，并进行模型参数分析。所提模型及模型参数计算公式与试验结果吻合良好，能较好地反映钢绞线网与ECC的界面黏结滑移特征。     

Quality assurance and quality control of subgrade compaction using the dynamic cone penetrometer

The Dynamic Cone Penetrometer (DCP) is a device that is used in the construction industry for the assessment of in situ soil compaction quality. Over the past few decades, numerous correlations have been developed between the DCP test results and soil strength and stiffness parameters. This paper proposes a comprehensive set of criteria and recommendations for quality control (QC) of compacted subgrade that take into account the inherent statistical variability of DCP test results. For the development of the QC criteria, a new statistical methodology is used to extract representative test values from the raw field DCP test data. In order to use the proposed QC criteria, soils are first classified into two broad categories (fine-grained and coarse-grained) depending on their fabric and response to compaction efforts. Test results indicate that (i) for fine-grained soils, the DCP test values have good correlation with the plasticity index (PI), which is indicative of the type and amount of clay content of the soil and (ii) for coarse-grained soils, the DCP test values have good correlation with the optimum water content of the soil, which is directly related to its in situ density. DCP blow count correlation equations are presented for both soil categories. Recommendations for field DCP testing and data analysis are also provided to highlight the significance of the statistical distribution of the DCP test results in QC testing of compacted subgrade.     

Data quality and uncertainty assessment methodology for pavement LCA

In performing pavement life cycle assessment (LCA), users are facing various reports of energy intensity coefficient (EIC) of pavement materials which differ considerably among data sources and therefore alter the LCA results significantly. Instead of selecting a certain EIC without or of little explanation for the current pavement LCA practices, this study proposed a methodology to build probability density function (PDF) for EIC based on available data-set and their qualities. Each data was first evaluated about the data quality indicator (DQI) through data quality pedigree matrix and converted to PDF in modified Beta distribution form. Three weighting methods, the DQI one, coefficient of variation (COV) one and analytical hierarchy process (AHP) one, were developed to assign weightings for different data. Monte Carlo simulation was run with the weighted PDF of each data as input to obtain the ultimate PDF for EIC. A case study to estimate the bitumen’s EIC with eight data samples were performed using the proposed methodology. It is found (1): the estimates by the proposed methodology is of higher reliability (lower COV) compared to any single data due to utilisation of information of the overall data samples; (2) the AHP weighting method is most favoured despite the results of the three weighting methods are close; (3) the central estimates of bitumen’s EIC are between5.4~5.8 MJ/kg. The proposed methodology is helpful in aiding calculating EICs for pavement materials and capturing uncertainties in LCA results in a statistical sense.     

臭氧氧化-循环喷淋法处理钨钼选矿废水

采用臭氧氧化-循环喷淋法去除钨钼选矿废水中COD,研究了pH值、臭氧流量、循环频率对COD去除效果的影响。结果表明: 废水COD去除率随pH值、臭氧流量、循环频率增大而增加,在pH值为10、臭氧流量3.0 L/min、循环频率4.0次/min条件下,氧化120 min后废水COD含量由131 mg/L降至11.5 mg/L,COD去除率达91.2%,满足《污水综合排放标准》(GB 8978-1996)一级标准。与O₂、NaClO处理废水COD的对比试验结果表明,循环喷淋法结合O₃表现出较好的COD去除效果。     

高职院校英语课堂的文化渗透研究

当代社会,高职院校迫切需要培养高素质技术技能型复合人才,其中高素质可以从培养学生文化素质方面提高。高职英语教师可通过口头、PPT、微课、第二课堂等方式在课内课外、线上线下渗透中外文化知识,进而提升学生对中国传统文化的自信心,拓展文化领域,开阔思路,提高综合素质。     

Cobalt ferrite nanoparticles prepared by microwave hydrothermal synthesis and adsorption efficiency for organic dyes: Isotherms,thermodynamics and kinetic studies

Magnetic nanoferrites (MFe₂O₄, M = Co, Ni) were successfully synthesised through microwave-hydrothermal route, characterised and used for adsorption of Eriochrome Black T (EBT) and Bromophenol Blue (BRB) dyes from their aqueous solution. The powder XRD patterns confirmed the formation of cubic spinel structure for both the ferrites. Under identical conditions, the adsorption efficiency of CoFe₂O₄ was found relatively higher than the corresponding NiFe₂O_4. Further characterisations revealed that CoFe₂O₄ sample was nearly spherical in size (8–9 nm) with narrow size distribution. The sample showed superparamagnetic behaviour with saturation magnetization (M_s) value (66.4 emu/g). BET surface area calculated for the synthesized cobalt ferrite as 70.9 m²/g. Batch adsorption experiments as a function of initial dye concentration, pH, contact time and adsorbent dose showed the adsorption of dyes depends on pH. Equilibrium adsorption data were well explained by both Langmuir and Freundlich isotherm models. The maximum monolayer adsorption capacities (Q_o) were found to be 82.6 and 25.6 mg/g for EBT and BRB dyes, respectively. Kinetics of the adsorption was best described by pseudo-second-order model. Various thermodynamic parameters such as ΔG, ΔH and ΔS derived from adsorption data over the temperature range 20–50 °C, accounted for a favourable, spontaneous, endothermic physisorption process. The materials showed potential for repeated use without significant decrease in adsorption capacity after proper regeneration.     

All the players in the game: driving home the global commitment for legitimate drugs

Substandard, falsified, and counterfeit medications are a concern for the industry and for the public’s health. Data collection and research on these illegitimate drugs must continue to be a priority and common recommendations must be implemented immediately. The health of the public continues to be at risk, and as such global consensus and collaboration must be swift. Process improvements and policy decisions can support expert recommendations while technology and research continue to drive home change. Addressing counterfeit and substandard drugs is cost effective, feasible, and the right thing to do.     

β-环糊精修饰Ni/SFCC强化C9石油树脂催化加氢性能

以废弃的流化催化裂化催化剂（简称SFCC）为载体、β-环糊精为金属络合剂、硝酸镍为镍源，采用湿法浸渍法制备β-环糊精修饰的Ni/SFCC催化剂（简称Ni/SFCC-CD催化剂），考察其对C9石油树脂的催化加氢性能。通过BET比表面积测试、H2程序升温还原、X射线光电子能谱等手段对催化剂的物相结构进行表征，研究β-环糊精的作用机理及其对催化剂加氢性能的影响。研究结果表明：在反应温度为260 ℃、反应压力为7 MPa、反应时间为2.0 h的最优条件下，采用Ni/SFCC-CD催化C9石油树脂加氢，可制得溴值为1.45 gBr/（100 g）、色号（加纳德）小于1的水白色氢化C9石油树脂，催化剂循环使用4次后仍保持良好活性；β-环糊精的作用机理是：β-环糊精与硝酸镍产生络合作用，抑制硝酸镍的分解、控制NiO的结晶过程和增强活性组分Ni与载体之间的相互作用力，从而提高了Ni/SFCC-CD的催化活性和稳定性。